Output Flange Seal, Replacing: Notes
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi S3, 2017 Audi RS 3, 2017 Audi A3 Quattro, 2016 Audi S3, and 2016 Audi A3 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Press Plate:VW401
- Press Plate:VW402
- Press Piece - Rod:VW407
- Press Piece - Multiple Use:VW412
- Press Piece - Bushing - 50 mm Diameter:VW454
- Press Piece - Multiple Use:VW455
- Support Channels:VW457
- Press Piece - Reverse Gear Syncro:3296
- Gearbox Support:T10108 with Gearbox Support Stop Plate:T10108/1
- Puller - Taper Roller Bearing:VAG1582
- Puller - Taper Roller Bearing - Adapter 13:VAG1582/13
- Torque Wrench:VAG1601
- Seal Installer - Crankshaft:VW204 B
- Dial Gauge Holder:VW387
- Press Piece - Multiple Use:40-105
- Socket 34 mm:T50019
- Dial Gauge - 0-10 mm:VAS6080
- Grease. Refer to the parts information.
- M10 x 30 bolt (quantity: 2)
- M8 x 25 bolt (quantity: 1)
- M12 x 10 nut (quantity: 4)
CAUTION:
This procedure contains mandatory replaceable parts. Refer to component overview prior to starting procedure.
Mandatory Replacement Parts
- Bolts - Drive Axle
- Nut - 12-Point
- O-ring - Pinion Housing
NOTE:
A tapered roller bearing inner race is installed on the bevel box output shaft.
This is removed later in the procedure.
Do not replace the tapered roller bearing for the output flange bevel box and the shim!