Right Flange Shaft, Removing And Installing, Vehicles With AWD: Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi S3, 2017 Audi RS 3, 2017 Audi A3 Quattro, 2016 Audi S3, and 2016 Audi A3 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- The transmission is installed.
- Pay attention to the general information. Refer to GENERAL INFORMATION .
- Follow the guidelines for clean working conditions. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .
- Follow the general repair information. Refer to GENERAL REPAIR INFORMATION .
-- Remove the nuts -arrows- and remove the right drive axle heat shield.
-- Remove the right drive axle. Refer to DRIVE AXLE .
-- Place the :SMN372500 underneath.
-- Remove the right flange shaft bolt using the :T10107A by installing two bolts in the flange and counterholding the flange shaft with an assembly lever.
-- Fasten the :T10037 to the right flange shaft as shown.
-- Align the :T10037 with the :T10037/1 and the spindle -A- so that it is parallel to the flange.
-- Remove the flange shaft.