Seal On Bevel Box Between Transmission And Bevel Box, Replacing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi S3, 2017 Audi RS 3, 2017 Audi A3 Quattro, 2016 Audi S3, and 2016 Audi A3 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Seal Installer - Bevel Box :T10298
- Puller - Crankshaft/Power Steering Seal :T20143
- Sealing Grease. Refer to the Parts information.
-- Remove the bevel box. Refer to BEVEL BOX, REMOVING .
-- Pry out the seal on the bevel box using the :T20143/1 or :T20143/2 .
-- Coat the outer circumference and sealing lips on the new seal with transmission fluid.
-- Fill the space between the sealing/dust lip -arrow- halfway with sealing grease. Refer to the Parts information for the correct sealing grease.
-- Drive the new seal all the way in using the :T10298 . Do not tilt it while doing so.
-- Install the bevel box. Refer to BEVEL BOX, REMOVING .