Right Seal, Replacing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi S3, 2017 Audi RS 3, 2017 Audi A3 Quattro, 2016 Audi S3, and 2016 Audi A3 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Seal Installer - Flange Shaft :T10049
- Puller - Crankshaft/Power Steering Seal :T20143
- Sealing Grease. Refer to the Parts information.
- The transmission is installed.
- Pay attention to the general information. Refer to GENERAL INFORMATION .
- Follow the guidelines for clean working conditions. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .
- Follow the general repair information. Refer to GENERAL REPAIR INFORMATION .
-- Remove the right flange shaft. Refer to RIGHT FLANGE SHAFT, REMOVING AND INSTALLING .
-- Remove the right seal using the :T20143/2 .
-- Coat the outer circumference and sealing lips on the new seal with transmission fluid.
-- Fill the space between the sealing/dust lip -arrow- halfway with sealing grease. Refer to the Parts information for the correct sealing grease.
-- Drive the new seal all the way in using the :T10049 . Do not tilt it while doing so.
-- Install the right flange shaft. Refer to RIGHT FLANGE SHAFT, REMOVING AND INSTALLING .
-- Check the gear oil level. Refer to GEAR OIL, CHECKING LEVEL .