Individual Parts Of The Disassembled Clutch
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2017 Audi S3, 2017 Audi A3 Quattro, 2016 Audi S3, 2016 Audi A3 Quattro, and 2016 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Risk of discs in double clutch slipping.
- The overview of the individual parts only serves to provide information, the clutch must not be disassembled at this time.
- If drive plate is loosened, the clutch discs in the clutch can slip out of place and the clutch may not be correctly set during installation under certain circumstances.
- Outer Clutch Pack Carrier with Clutch Housing
- Seals
- Quantity: 4
- Inner Clutch Pack CarrierCAUTION:
Risk of plates slipping.
- If the inner clutch pack carrier is raised or removed, plates can slip. The double clutch can no longer be adjusted correctly.
- Outer Discs
- Quantity: 4
- Inner Discs
- Quantity: 4
- Thrust Washer
- Locking Ring
- If the securing ring was removed in order to install the discs, it should be replaced with a new ring of the same thickness.
- Locking Ring
- Determine thickness when installing multi-plate clutch. Refer to DUAL CLUTCH, INSTALLING b
- Drive Plate
- Locking Ring
- Always replace after removing