Installing: Notes
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2017 Audi S3, 2017 Audi A3 Quattro, 2016 Audi S3, 2016 Audi A3 Quattro, and 2016 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
-- Use special caution when removing the dual clutch from the packaging.
- Do not remove or lift the clutch pack, not even a small amount. The clutch plates can rotate themselves.
- If the drive plate comes out of the outer clutch plate carrier teeth, the plates can slip. The dual clutch can then no longer be adjusted correctly.
- To ensure that the multiplate clutch plates do not slip, press the drive plate into the outer clutch plate carrier with both thumbs during all of the following steps.
-- Check on the bottom of the dual clutch if the four hub seals are seated correctly and engage them in one another if necessary.
- Installation position: the ends of the rings are offset to each other.