Installation Position Of The Drive Plate
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2017 Audi S3, 2017 Audi A3 Quattro, 2016 Audi S3, 2016 Audi A3 Quattro, and 2016 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
- The protruding tab -arrow- must be positioned between the color-marked teeth of the outer clutch plate carrier.
- If no mark is present, the tab to the outer clutch plate carrier is marked all around with color.
- When installing, the drive plate tab must be placed back on this marked location.
-- Position the :T10303 on the clutch end cover seat as shown.
-- Insert the dual clutch in clutch bell housing by turning and lifting and pressing drive plate into outer clutch pack carrier with both thumbs in direction of -arrows-.
- Do not let the dual clutch fall into the inner clutch plate carrier.
-- Have a second technician hold the :T10303 as shown until the clutch end cover is installed.
- To prevent the :T10303 from rotating in place, do not turn the dual clutch.
-- Pry out the circlip -2- using a screwdriver -1- in direction of -arrow-.
-- Remove the drive plate in direction of -arrows-. To do so, carefully pry the drive plate out of the outer clutch plate carrier teeth using a screwdriver if necessary.
Tip
- If the inner clutch plate carrier is removed or raised, the plates can slip. The dual clutch can then no longer be adjusted correctly.
-- Move the drive plate to the side.