Clutch End Cover Without Bushing:

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2017 Audi S3, 2017 Audi A3 Quattro, 2016 Audi S3, 2016 Audi A3 Quattro, and 2016 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI OF AMERICA, LLC

-- Place the :T10302 on a level surface.

Courtesy of AUDI OF AMERICA, LLC

-- To pre-form the inner seal on the new clutch end cover, guide the clutch end cover with the outer side facing downward evenly and horizontally over the :T10302 .

-- Remove the :T10302 upward out of the clutch end cover.

-- Place the :T10302 on the end of the dual clutch shaft.

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

Risk of Leaks on the Clutch End Cover.

Transmission Damage Due to Oil Loss.

- Do not touch the seal in the inner opening of the clutch end cover!

- Do not load the clutch end cover by hitting with a hammer.

-- Guide the clutch end cover with the outer side facing upward horizontally over the :T10302 and press it evenly into its seat.

-- If necessary, carefully pry the clutch end cover into its seat with a screwdriver -arrow- as shown until the shaft ring can be installed.

Courtesy of AUDI OF AMERICA, LLC

-- Install the clutch end cover shaft ring in the transmission housing by counterholding the shaft ring on the opposite side so that it stays in its groove.

-- Using a screwdriver, make sure the shaft ring is completely engaged.

-- Remove the :T10302 .