Fuel Level Sensor 2 -G169-, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi S3, 2017 Audi RS 3, 2017 Audi A3 Quattro, 2016 Audi S3, and 2016 Audi A3 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Replace the seal after removal.
Pull on the connectors to make sure they are securely connected and correctly locked.
-- Insert the Fuel Level Sensor 2 -G169- in the guides on the bracket and push down until it engages.
-- Install a new sealing flange seal -1-. It must be dry.
CAUTION:
Risk of leaking.
- When inserting the sealing flange, the seal must not be damaged or crushed.
-- Bring the sealing flange into its installation position.
- The tab -2- on the sealing flange must face the hole -arrow- in the locking ring and rest between the tabs -3 and 4- on the fuel tank.
-- Insert the locking ring and fasten using the :T10202 .
Further installation is performed in reverse order of removal, while noting the following:
-- Install the rear bench seat. Refer to BENCH SEAT/SINGLE SEAT, REMOVING AND INSTALLING .