LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A3 Premium, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Fuel Supply System -- (A3 Sedan)) >> 20 Fuel Supply System >> Sensors >> Fuel Level Sensor -G-, Removing And Installing >> Removing

Fuel Level Sensor -G-, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi S3, 2017 Audi RS 3, 2017 Audi A3 Quattro, 2016 Audi S3, and 2016 Audi A3 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Observe the safety instructions. Refer to SAFETY PRECAUTIONS .

-- Follow the guidelines for clean working conditions. Refer to CLEAN WORKING CONDITIONS .

-- Remove the fuel delivery unit. Refer to FUEL DELIVERY UNIT/FUEL LEVEL SENSOR, REMOVING AND INSTALLING .

With Front Wheel Drive (FWD), Without High-Voltage System: 

Fig 1: Identifying Fuel Level Sensor And Retainers
GWWA20-11011Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connectors -1- on the sealing flange by unlocking the connector safety catch.

-- Disengage and free up the wires on the bracket -arrow-.

-- Release the tab on the retainers -3 and 4- and at the same time, remove the Fuel Gauge Sensor -G- -2- upward.

With Front Wheel Drive (FWD), With High-Voltage System: 

GWWA20-11418Courtesy of AUDI OF AMERICA, LLC

-- Release the connector in direction of -arrow-, and disconnect the connector -1- on the sealing flange.

-- Disengage and free up the wires on the bracket.

-- Disconnect the retainers -2 and 3- on the tabs and at the same time remove the Fuel Gauge Sensor -G- upward.

Vehicles With 4-Cylinder Engines and All Wheel Drive (AWD): 

GWWA20-11074Courtesy of AUDI OF AMERICA, LLC

-- Release the connector safety catch, and disconnect the connector -4- on the sealing flange.

-- Disengage and free up the wires on the bracket -arrow-.

-- Release the tab -1 and 2- on the retainers and at the same time remove the Fuel Gauge Sensor -G- -3- upward.

Vehicles With 5-Cylinder Engine: 

GWWA20-11426Courtesy of AUDI OF AMERICA, LLC

-- Release the connector safety catch and disconnect the connector -2- from the sealing flange.

-- Disengage and free up the wires on the bracket.

-- Release the retainers -1 and 3- in direction of -arrows A- and press out the Fuel Gauge Sensor -G- upward in direction of -arrow B-.