Overview - Fuel Tank, USA And CANADA Market Versions With AWD
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi S3, 2017 Audi RS 3, 2017 Audi A3 Quattro, 2016 Audi S3, and 2016 Audi A3 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Heat Shield
- For the fuel tank
- Right Mounting Strap
- Bolt
- 20 Nm + 90°
- Always replace after removing
- Fuel Line
- To the engine
- Do not kink
- Clipped to the fuel tank
- Connector coupling, separating and connecting. Refer to CONNECTOR COUPLINGS, DISCONNECTING .
- Breather Line
- To EVAP Canister Purge Regulator Valve 1 -N80-
- Do not kink
- Clipped to the fuel tank
- Connector coupling, separating and connecting. Refer to CONNECTOR COUPLINGS, DISCONNECTING .
- Bolt
- 8 Nm + 90°
- Always replace after removing
- To attach the fuel filler neck
- For discharging electrostatic charge. Refer to Figure.
- Ground Connection
- For fuel filler tube
- For discharging electrostatic charge. Refer to Figure.
- Cap
- Turn until it clicks into place.
- Attached to the fuel filler door unit with fastening device
- Breather Line
- To the Evaporative Emission (EVAP) canister
- Do not kink
- Clipped to the fuel tank
- Connector coupling, separating and connecting. Refer to CONNECTOR COUPLINGS, DISCONNECTING .
- Breather Line
- To the EVAP canister
- Do not kink
- Connector coupling, separating and connecting. Refer to CONNECTOR COUPLINGS, DISCONNECTING .
- Bolt
- 8 Nm + 90°
- Always replace after removing
- Bolts
- 20 Nm + 90°
- Always replace after removing
- Fuel Tank
- Removing and installing. Refer to FUEL TANK, REMOVING AND INSTALLING, AWD VEHICLES .
- Left Mounting Strap
- Bolt
- 20 Nm + 90°
- Always replace after removing
- Nut
- 2 Nm
- For heat shield