Overview - Fuel Tank, A3/SPORTBACK/Sedan With Fwd And Torsion Beam Axle
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi S3, 2017 Audi RS 3, 2017 Audi A3 Quattro, 2016 Audi S3, and 2016 Audi A3 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 20 Nm + 90°
- Always replace after removing
- Mounting Strap
- Nut
- 2 Nm
- For heat shield
- Heat Shield
- For the fuel tank
- Bolts
- 20 Nm + 90°
- Always replace after removing
- Fuel Line to the Parking Heater
- Equipment levels
- Do not kink
- Connector couplings, disconnecting and connecting. Refer to CONNECTOR COUPLINGS, DISCONNECTING .
- Fuel Supply Line
- To the engine
- Clipped to the fuel tank
- Do not kink
- Connector coupling, separating and connecting. Refer to CONNECTOR COUPLINGS, DISCONNECTING .
- Breather Line
- To EVAP Canister Purge Regulator Valve 1 -N80-
- Clipped to the fuel tank
- Do not kink
- Connector coupling, separating and connecting. Refer to CONNECTOR COUPLINGS, DISCONNECTING .
- Bracket
- For the Fuel Pump Control Module -J538-
- Bolt
- Tightening specification. Refer to
- Fuel Filter
- Removing and installing. Refer to
- Bolt
- 8 Nm + 90°
- Always replace after removing
- Cap
- Turn until it clicks into place.
- Attached to the fuel filler door unit with fastening device
- Screw
- 8 Nm
- To attach the fuel filler neck
- For discharging electrostatic charge. Refer to Figure.
- Ground Connection
- For fuel filler tube
- For discharging electrostatic charge. Refer to Figure.
- Breather Line
- To the Evaporative Emission (EVAP) canister
- Clipped to the fuel tank
- Do not kink
- Connector coupling, separating and connecting. Refer to CONNECTOR COUPLINGS, DISCONNECTING .
- Breather Line
- To the EVAP canister
- Clipped to the fuel tank
- Do not kink
- Connector coupling, separating and connecting. Refer to CONNECTOR COUPLINGS, DISCONNECTING .
- Bolt
- 20 Nm + 90°
- Always replace after removing
- Fuel Tank
- Removing and installing. Refer to FUEL TANK, REMOVING AND INSTALLING, FWD VEHICLES AND TORSION BEAM AXLE .
- Bolt
- 20 Nm + 90°
- Always replace after removing
- Bolt
- 20 Nm + 90°
- Always replace after removing