Overview - Fuel Tank, A3/SPORTBACK/Sedan With Fwd And Multi-Link Suspension
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi S3, 2017 Audi RS 3, 2017 Audi A3 Quattro, 2016 Audi S3, and 2016 Audi A3 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Fuel Line to Parking Heater
- Equipped on some models
- Do not kink
- Connector Couplings, Disconnecting and Connecting. Refer to CONNECTOR COUPLINGS, DISCONNECTING .
- Fuel Supply Line
- To the engine
- Clipped to the fuel tank
- Do not kink
- Connector Couplings, Disconnecting and Connecting. Refer to CONNECTOR COUPLINGS, DISCONNECTING .
- Bleeder Line
- To the EVAP Canister Purge Regulator Valve 1 -N80-
- Clipped to the fuel tank
- Do not kink
- Connector Couplings, Disconnecting and Connecting. Refer to CONNECTOR COUPLINGS, DISCONNECTING .
- Bracket
- For Fuel Pump Control Module -J538-
- Bolt
- Replace after removing.
- 20 Nm +90°
- Bolt
- Replace after removing.
- 8 Nm +90°
- Cap
- Turn until it clicks into place.
- Attached to the fuel filler door unit with fastener
- Bolt
- For securing the fuel filler neck
- For discharging electrostatic charge. Refer to Figure.
- Replace after removing.
- 8 Nm +90°
- Ground Connection
- For the fuel filler neck
- For discharging electrostatic charge. Refer to Figure.
- Bleeder Line
- To the EVAP Canister
- Clipped to the fuel tank
- Do not kink
- Connector Couplings, Disconnecting and Connecting. Refer to CONNECTOR COUPLINGS, DISCONNECTING .
- Bleeder Line
- To the EVAP Canister
- Clipped to the fuel tank
- Do not kink
- Connector Couplings, Disconnecting and Connecting. Refer to CONNECTOR COUPLINGS, DISCONNECTING .
- Fuel Tank
- Removing and Installing. Refer to FUEL TANK, REMOVING AND INSTALLING, FWD VEHICLES AND MULTI-LINK SUSPENSION .
- Bolt
- Replace after removing.
- 20 Nm +90°
- Nut
- For the heat shield
- 2 Nm
- Heat Shield
- For the fuel tank
- Mounting Strap
- Bolts
- Replace after removing.
- 20 Nm +90°