Transfer Fuel Pump -G6-, Checking, Vehicles With 3/4-Cylinder Engine: Assembling

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi S3, 2017 Audi RS 3, 2017 Audi A3 Quattro, 2016 Audi S3, and 2016 Audi A3 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Assemble in the reverse order of removal. Note The Following:

The ignition must be off.

NOTE:

Decrease the fuel pressure by opening the shut-off valves -B and C- and letting the fuel run into the measuring container before removing the pressure gauge -1-.

Fig 1: Identifying Shut-Off Valves A And B On Pressure Tester Kit

Courtesy of AUDI OF AMERICA, LLC

-- Remove the :VAS6550 with the connecting cables.

-- Attach the fuel supply line so that it clicks into place.

-- Press on the fuel supply line again and pull it to make sure the connector coupling is engaged correctly.

Vehicles Without High Voltage System:

-- Install the rear bench seat. Refer to BENCH/REAR - SEAT/SINGLE SEAT, REMOVING AND INSTALLING Rear Seats .

Vehicles With High Voltage System:

-- Install the luggage compartment floor. Refer to OVERVIEW - LUGGAGE COMPARTMENT FLOOR .

-- Install The Rear Shelf. Refer to REAR SHELF, REMOVING AND INSTALLING .