Fuel Tank Leak Detection Control Module -J909-, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi S3, 2017 Audi RS 3, 2017 Audi A3 Quattro, 2016 Audi S3, and 2016 Audi A3 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Fuel Tank Leak Detection Control Module -J909

Courtesy of AUDI OF AMERICA, LLC

-- Disengage the bracket -1- for the control module from the mount -2- on the fuel tank.

-- To do this grasp the control module -3- by hand and carefully turn back and forth in direction of -arrows-, until the catches loosen.

-- Disengage the control module -2- with the bracket -4- from the catches and remove downward.

Fig 2: Safety Catch/Connector For Fuel Tank Leak Detection Control Module -J909

Courtesy of AUDI OF AMERICA, LLC

-- Release the connector safety catch and disconnect the connector -1-.

-- Remove the bolts -3 and 5- and the control module from the bracket.