LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A3 Premium, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Fuel Supply System -- (A3 Sedan)) >> 20 Fuel Supply System >> Accelerator Mechanism >> Accelerator Pedal Position Sensors -G79- / -G185-, Removing And Installing >> Installing

Accelerator Pedal Position Sensors -G79- / -G185-, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi S3, 2017 Audi RS 3, 2017 Audi A3 Quattro, 2016 Audi S3, and 2016 Audi A3 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and Note The Following: 

CAUTION:

There is a risk of damaging the surface of the knee airbag from mechanical stress.

  • After completing a procedure, perform a visual inspection to make sure that the surface of the knee airbag is not damaged.

-- Install the steering column cover. Refer to STEERING COLUMN COVER, REMOVING AND INSTALLING .

NOTE:

Depending on the engine/transmission combination, an adaptation must be performed after replacing.

If a corresponding menu item is in the engine electronics tree structure under "functions", perform the adaptation using the Vehicle Diagnostic Tester.