Transmission Mount, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2017 Audi S3, 2017 Audi A3 Quattro, 2016 Audi S3, 2016 Audi A3 Quattro, and 2016 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the battery tray -1-. Refer to BATTERY .

Courtesy of AUDI OF AMERICA, LLC

-- Remove the Engine Control Module -J623- from the bracket. Refer to Engine Control Module -J623-, REMOVING AND INSTALLING .

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows- and remove the bracket -1-.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Depending on the version different brackets are installed.

-- Unclip the wiring guide -1- upward in direction of -arrows- and move it slightly to the side.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The illustration shows a vehicle with dual-clutch transmission 0CW.

Courtesy of AUDI OF AMERICA, LLC

-- If applicable, remove the nut -arrow- and free up the ground cable.

-- Support the engine in the installation position. Refer to ENGINE, SUPPORTING IN INSTALLATION POSITION .

-- Remove the bolts -arrows- and remove the transmission mount.

Courtesy of AUDI OF AMERICA, LLC

Transmission mount -1- for the manual transmission 02S/dual-clutch transmission 0CW

Transmission mount -1- for the manual transmission 02Q/dual-clutch transmission 0D9

Courtesy of AUDI OF AMERICA, LLC