Engine And Transmission, Separating, Vehicles With Manual Transmission 02S: Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2017 Audi S3, 2017 Audi A3 Quattro, 2016 Audi S3, 2016 Audi A3 Quattro, and 2016 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
- Engine/transmission assembly removed and mounted on :T10359A .
-- Remove the starter. Refer to STARTER .
-- Free up the wiring harness -1 and 2- from the air duct pipe.
-- Loosen the screw-type clamp -4-.
-- Remove the bolts -arrows- and remove the air duct pipe.
-- Remove the bolts -arrows- and transmission support -A- from the transmission.
-- Secure the transmission to the :VAS6100 using the :2024A as shown.
NOTE:
To be aligned to the center of gravity of the assembly, the rails with holes of the lifting hooks must be inserted as shown.
WARNING:
Risk of accident due to loose engine support bridge components.
- Secure the mounting hooks and pins on the engine support bridge using securing pins -arrows-.
-- Remove the bolts -1, 2, 3, 6, 7, 8 and 9- connecting the transmission to the engine.
-- Remove the transmission from the engine.