Overview - Muffler, Vehicles With Fwd: Notes
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2017 Audi S3, 2017 Audi A3 Quattro, 2016 Audi S3, 2016 Audi A3 Quattro, and 2015 Audi S3. However, it is still accessible from the selected car via links, so may be relevant.
- Rear Muffler
- Original equipment as one unit with the rear muffler. If a repair is required replace each separately
- Removing and installing. Refer to MUFFLER, REMOVING AND INSTALLING .
- Separating point. Refer to EXHAUST PIPES/MUFFLERS, DISCONNECTING .
- Exhaust System, Installing without Tension. Refer to EXHAUST SYSTEM, INSTALLING WITHOUT TENSION .
- Bolt
- 20 Nm
- Bracket
- Retaining Loop
- Replace if damaged
- Rear Clamping Sleeve
- Before tightening, align the exhaust system without tension. Refer to EXHAUST SYSTEM, INSTALLING WITHOUT TENSION .
- Installation position. Refer to INSTALLATION POSITION FOR REAR CLAMPING SLEEVE .
- Tighten threaded connections evenly.
- Nut
- 20 Nm
- Bolt
- 20 Nm
- Bracket
- Retaining Loop
- Replace if damaged
- Center Muffler
- Original equipment as one unit with the rear muffler. If a repair is required replace each separately
- Removing and installing. Refer to MUFFLER, REMOVING AND INSTALLING .
- Separating point. Refer to EXHAUST PIPES/MUFFLERS, DISCONNECTING .
- Exhaust System, Installing without Tension. Refer to EXHAUST SYSTEM, INSTALLING WITHOUT TENSION .
- Retaining Loop
- Replace if damaged
- Bracket
- Bolt
- 20 Nm
- Retaining Loop
- Replace if damaged
- Trim
- For the tail pipes