Overview - Cylinder Block, Transmission Side
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 Audi S3, 2017 Audi A3 Quattro, 2016 Audi S3, 2016 Audi A3 Quattro, and 2016 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
- Flywheel
- Removing and installing. Refer to FLYWHEEL, REMOVING AND INSTALLING .
- Only possible to install in one position - holes are offset -
- Alignment Sleeve
- Transmission Side Sealing Flange
- Always replace after removing
- With gasket
- Do not apply oil to the seal.
- Before installing, remove oil residue from crankshaft journal with a clean cloth.
- The guide sleeve may only be removed after the sealing flange has been slid onto the crankshaft journal.
- Removing and installing. Refer to SEALING FLANGE, REMOVING AND INSTALLING, TRANSMISSION SIDE .
- Cylinder Block
- Bolt
- Intermediate Plate
- The illustration does not show the version in the vehicle.
- Be careful not to damage or bend when installing
- Installing. Refer to Fig 4.
- Alignment Sleeve
- Bolt
- Always replace after removing
- 60 Nm + 90°
-- Tighten the new bolts in steps in the sequence shown:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -1 to 6- | Install by hand all the way |
| 2. | -1 to 6- | 9 Nm |
TIP:
Only six bolts are installed, two bolt openings remain open.
-- Tighten the bolts in the steps shown in the sequence:
| Step | Bolts | Tightening Specifications |
|---|---|---|
| 1. | -1 to 8- | Install by hand all the way |
| 2. | -1 to 8- | 9 Nm |
-- Hang the intermediate plate on the sealing flange -arrow upper - and slide it on the alignment sleeves -arrows lower -.