Crankshaft Needle Bearing, Replacing: Installing
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 Audi S3, 2017 Audi A3 Quattro, 2016 Audi S3, 2016 Audi A3 Quattro, and 2016 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
-- Clean the bearing seat in the crankshaft and apply a thin coat of grease.
-- Drive the needle bearing into the crankshaft up to the installation depth using the :VW207C .
- If the needle bearing is unintentionally pushed in to deeply, it must be replaced, because it will be damaged when it is removed again.