Rear Muffler, Removing And Installing, Vehicles With Front Wheel Drive And Torsion Beam Axle: Installing

WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Install In Reverse Order Of Removal. Note The Following:

Replace the seal.

-- Pay attention to the installation position:

Refer to INSTALLED LOCATION OF THE FRONT EXHAUST PIPE SCREW CLAMP
Refer to INSTALLED LOCATION OF THE SEAL BETWEEN THE EMISSIONS CONTROL MODULE AND FRONT EXHAUST PIPE. .
Refer to INSTALLED POSITION OF FRONT CLAMPING SLEEVE .
Refer to INSTALLED POSITION OF REAR CLAMPING SLEEVE .

-- Refer to EXHAUST SYSTEM, INSTALLING AND ALIGNING .