EGR Motor 2 -V339-, Removing And Installing: Removing
WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .
-- If installed: Disconnect the vacuum hose -arrow- and free it up.
-- Press the release button on the crankcase ventilation hose -1- and remove the hose from the cylinder head.
-- Free up the vacuum hose on the air guide pipe -arrows-.
-- Open hose clamp -3-, remove the Mass Airflow Sensor -G70- air guide pipe.
-- Remove bolt -2- and tilt the air guide pipe with the intake tube backward and remove from the turbocharger.
-- Loosen the hose clamps -1 and 2-, and remove the EGR vacuum regulator solenoid valve hose.
-- Push the heat shield boot aside, and disconnect the connector -3-.
-- Remove the bolts -arrows- and the EGR Motor 2 -V339-.