Heater Support Pump -V488-, Removing And Installing: Removing
WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
- The engine is cold.
-- Reduce the residual pressure in the cooling system: cover the coolant expansion tank cap -arrow- with a cloth then carefully open quickly and then close.
-- Remove the noise insulation -1-. Refer to NOISE INSULATION, REMOVING AND INSTALLING / OVERVIEW - NOISE INSULATION .
-- Disconnect the connector -3-.
-- To catch escaping coolant place a clean cloth under the separation point.
-- Clamp off the coolant hoses with the :3094 .
-- Loosen the clamps -4- and remove the coolant hoses.
-- Disengage the Heater Support Pump -V488- -2- from the retaining loop -1-.