Coolant Thermostat, Removing And Installing: Installing
WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
Install In Reverse Order Of Removal. Note The Following:
- Replace the O-rings.
-- Clean and smooth the O-ring sealing surface.
-- Coat the new O-ring with coolant.
-- Place the coolant thermostat -2- in the coolant thermostat housing.
- The retaining tabs must engage in the guides in direction of -arrows-.
-- Install the Throttle Valve Control Module -J338-. Refer to THROTTLE VALVE CONTROL MODULE -J338-, REMOVING AND INSTALLING .
CAUTION:
- The coolant system must be bled using the Vehicle Diagnostic Tester after filling.
-- Fill and bleed the coolant circuit. Refer to COOLANT, DRAINING AND FILLING WITHOUT COOLING SYSTEM CHARGE KIT - ELECTRIC VACUUM PUMP:VAS6096/2 .