Right Rear Coolant Pipe, Removing And Installing: Installing

WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Install In Reverse Order Of Removal. Note The Following:

Replace the O-ring.
Secure all hose connections with hose clamps that match the ones used in series production. Refer to the Parts information.

-- Install the emissions control module. Refer to EMISSIONS CONTROL MODULE, REMOVING AND INSTALLING .

-- Install the front exhaust pipe. Refer to FRONT EXHAUST PIPE, REMOVING AND INSTALLING .

-- Install the rear coolant pipes. Refer to REAR COOLANT PIPE, REMOVING AND INSTALLING .

-- Install the left coolant pipes. Refer to LEFT COOLANT PIPES, REMOVING AND INSTALLING .

-- Install all heat shield boots back in the same positions.

-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

CAUTION:

- Fill the coolant system using only the Vehicle Diagnostic Tester.

-- Fill and bleed the coolant circuit. Refer to COOLANT, DRAINING AND FILLING WITHOUT COOLING SYSTEM CHARGE KIT - ELECTRIC VACUUM PUMP:VAS6096/2 .