Overview - Coolant Pump/Coolant Thermostat, Engine With Mechanical Coolant Thermostat: Notes
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2017 Audi S3, 2017 Audi RS 3, 2016 Audi S3, 2016 Audi A3, and 2015 Audi S3. However, it is still accessible from the selected car via links, so may be relevant.
- Connection
- O-ring
- Replace after removing.
- Coat with coolant
- Bolt
- Tightening specification and sequence. Refer to THERMOSTAT - TIGHTENING SPECIFICATION AND TIGHTENING SEQUENCE .
- Centering Pin
- Seal
- Replace after removing.
- Seal
- Replace after removing.
- Coolant Pump
- Removing and installing. Refer to COOLANT PUMP, REMOVING AND INSTALLING .
- Bolt
- Tightening specifications. Refer to COOLANT SYSTEM/COOLANT .
- Bolt
- Tightening specifications. Refer to COOLANT SYSTEM/COOLANT .
- Toothed Belt
- For the coolant pump
- Removing and installing. Refer to COOLANT PUMP TOOTHED BELT, REMOVING AND INSTALLING .
- Toothed Belt Guard
- Bolt
- Tightening specifications. Refer to COOLANT SYSTEM/COOLANT .
- Toothed Belt Sprocket
- Note the installation position
- Seal
- For the intake side balance shaft
- Replacing. Refer to BALANCE SHAFT .
- Balance Shaft
- Bolt
- 9 Nm
- Connection
- Coolant Thermostat
- Removing and installing. Refer to THERMOSTAT - TIGHTENING SPECIFICATION AND TIGHTENING SEQUENCE .
- O-ring
- Replace after removing.
- Coolant Thermostat Housing
- Removing and installing. Refer to COOLANT THERMOSTAT HOUSING, REMOVING AND INSTALLING .