Coolant Pump, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2017 Audi S3, 2017 Audi RS 3, 2016 Audi S3, 2016 Audi A3, and 2015 Audi S3. However, it is still accessible from the selected car via links, so may be relevant.
-- Drain the coolant. Refer to COOLANT, DRAINING AND FILLING .
-- Remove the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .
-- Loosen the hose clamp -1-, remove the air duct hose from the charge air cooler.
-- Variation: free up the secondary air injection hose -3- or the coolant hose.
-- Free up the wiring harness -1 and 2- from the air duct pipe.
-- Loosen the screw-type clamp -4-.
-- Remove the bolts -arrows- and remove the air duct pipe.
-- Remove the bolt -arrow- on the left and right.
-- Unclip and remove the lower section -1- of the air duct.
-- Lift the clamp -2-, remove the coolant supports and push them to the side.
All additional procedures are described. Refer to COOLANT PUMP/COOLANT THERMOSTAT .