Engine Speed Sensor -G28-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Noise Insulation

Courtesy of AUDI OF AMERICA, LLC

-- Remove the noise insulation -1-. Refer to OVERVIEW - NOISE INSULATION .

-- Disconnect the connector -1- using the Elbow Assembly Tool :T10118 .

Fig 2: Identifying Electrical Connector And Bolt

Courtesy of AUDI OF AMERICA, LLC

TIP:

To release the connector without the Elbow Assembly Tool :T10118 , use a screwdriver to push the connector on the engine speed sensor and at the same time lift up the release button using a thin wire hook.

-- Remove the bolt -2- using the Hex Socket - 4mm :T10370 and remove the Engine Speed Sensor -G28-.