Camshaft Position Sensor -G40-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Remove the bolts -arrows- and press the fuel lines forward.

Fig 1: Identifying Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -2-.

-- Remove the bolt -1- and remove the Camshaft Position Sensor -G40-.