Overview - One-Piece Oil Pan
WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- Self-locking
- Replace after removing
- 8 Nm
- On the emissions standard EU5 the Oil Level Thermal Sensor -G266- is secured with self-locking nuts.
- Oil Level Thermal Sensor -G266-
- Removing and Installing. Refer to Oil Level Thermal Sensor -G266-, REMOVING AND INSTALLING .
- Seal
- Replace after removing
- Oil Drain Plug
- 30 Nm
- Seal
- Replace after removing
- Bolt
- Tightening specification and sequence. Refer to Fig 2.
- Oil Pan
- Removing and Installing. Refer to TRANSMISSION FLUID PAN, REMOVING AND INSTALLING .
- O-Ring
- Replace after removing
- Bolt
- Replace after removing
- 12 Nm +180°
- Oil Pump
- With vacuum pump
- Removing and Installing. Refer to OIL PUMP, REMOVING AND INSTALLING .
- Alignment Sleeve
- Toothed Belt
- Do not kink, turn or damage the toothed belt with sharp edges
- Removing:
- Remove the oil pump. Refer to OIL PUMP, REMOVING AND INSTALLING .
- Remove the belt pulley side sealing flange. Refer to SEALING FLANGE, REMOVING AND INSTALLING, BELT PULLEY SIDE .
- Seal
- Replace after removing
- Alignment Sleeve
- Cylinder Block
- O-Ring
- Replace if damaged or leaking
- Oil Pressure Regulation Valve -N428-
- Removing and Installing. Refer to Oil Pressure Regulation Valve -N428-, REMOVING AND INSTALLING .
- Bolt
- 8 Nm
- Bolt
- 8 Nm
- Oil Dipstick Tube
- Bolt
- 8 Nm
- O-Ring
- Replace after removing
- Bolt
- Replace after removing
- 8 Nm +90°
- Splash Wall
- Oil Intake Pipe
Oil Pan - Tightening Specifications and Sequence
-- Tighten the bolts in stages as follows:
| Step | Bolts | Tightening Specification |
|---|---|---|
| 1. | -1 through 18- | Diagonally to 5 Nm |
| 2. | -arrows- | 40 Nm |
| 3. | -1 through 18- | Diagonally in stages to 13 Nm |