Charge Air Pressure Actuator -V465-, REMOVING AND INSTALLING: Removing

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2018 Audi S3, 2018 Audi A3 Quattro, 2017 Audi S3, 2017 Audi A3 Quattro, and 2016 Audi S3. However, it is still accessible from the selected car via links, so may be relevant.

Observe the guidelines for clean working conditions. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .

Vehicles with a particulate filter

-- Remove the particulate filter. Refer to CATALYTIC CONVERTER, REMOVING AND INSTALLING, VEHICLES WITH PARTICULATE FILTER .

AWD vehicles without particulate filter.

-- Remove the catalytic converter. Refer to CATALYTIC CONVERTER, REMOVING AND INSTALLING, VEHICLES WITHOUT PARTICULATE FILTER .

FWD vehicles without particulate filter.

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the clamping sleeve -arrow-.

-- Remove the bolts -arrows-.

Fig 1: Exhaust System Bracket

Courtesy of AUDI OF AMERICA, LLC

-- Press the catalytic converter together with the front exhaust pipe to the side.

Continuation for All Vehicles

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -4-.

-- Loosen the lock nut -2- a quarter turn, to do so counterhold on the control rod hex fitting -arrow-.

-- Remove the control rod from the operating lever -1- at the same time do not turn the lock nut.

-- Remove the bolts -3- and then the Charge Air Pressure Actuator -V465-.