Charge Air Pressure Actuator -V465-, REMOVING AND INSTALLING: Installing
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2018 Audi S3, 2018 Audi A3 Quattro, 2017 Audi S3, 2017 Audi A3 Quattro, and 2016 Audi S3. However, it is still accessible from the selected car via links, so may be relevant.
- If the charge air pressure actuator is replaced, apply the installation position of the lock nut on the new charge air pressure actuator.
-- Bring the Charge Air Pressure Actuator -V465- into the installation position and tighten the bolts -3-.
-- Install the control rod until it contacts the lock nut -2- in the operating lever -1-.
-- Connect the connector -4-.
-- If the Charge Air Pressure Actuator -V465- is replaced, the adaptation value must be adapted using the Vehicle Diagnostic Tester.
-- Connect the Vehicle Diagnostic Tester.
-- Select Diagnostic operating mode and Start diagnostics .
-- Select the Select individual test tab and select the following tree structure consecutively:
- Drivetrain
- Select the engine code and engine
- 01 - OBD-capable systems .
- 01 - Engine Electronics
- 01 - Engine electronics, functions
- 01 - Charge Air Pressure Actuator -V465 adjusting
Further installation is the reverse order of removal.