Overview - SUBFRAME Mount
- 1 - Bolt
- Tightening Specifications and Sequence. Refer to Fig 2.
- Replace after removing.
- 2 - Engine Support
- Removing and installing. Refer to ENGINE SUPPORT, REMOVING AND INSTALLING .
- 3 - Engine Mount
- With support arm
- Removing and installing. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .
- 4 - Bolt
- 40 Nm +90°
- Replace after removing.
- 5 - Bolt
- Replace after removing.
- 20 Nm +90°
- 6 - Bolt
- 40 Nm +90°
- Replace after removing.
- 7 - Bolt
- 40 Nm +90°
- Replace after removing.
- 8 - Pendulum Support
- Removing and installing. Refer to PENDULUM SUPPORT, REMOVING AND INSTALLING .
- 9 - Bolt
- Tightening Specifications and Sequence. Refer to Fig 3.
- Replace after removing.
- 10 - Bolt
- Tightening Specifications and Sequence. Refer to Fig 3.
- Replace after removing.
- 11 - Bolt
- Tightening Specifications and Sequence. Refer to Fig 3.
- Replace after removing.
- 12 - Bolt
- Tightening specifications. Refer to SUBFRAME MOUNT [For transmission(s) 0GC]SUBFRAME MOUNT [For transmission(s) 0D9] .
- 13 - Bolt
- Tightening specifications. Refer to SUBFRAME MOUNT [For transmission(s) 0GC]SUBFRAME MOUNT [For transmission(s) 0D9] .
- 14 - Transmission Mount
- With support arm
- Removing and installing. Refer to TRANSMISSION MOUNT, REMOVING AND INSTALLING .
- 15 - Bolt
- Tightening specifications. Refer to SUBFRAME MOUNT [For transmission(s) 0GC]SUBFRAME MOUNT [For transmission(s) 0D9] .
- Replace the bolts that were tightened with an additional turn.
-- Tighten the bolts in the steps shown in the sequence:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -1 to 3- | 7 Nm |
| 2. | -1 to 3- | 40 Nm |
| 3. | -1 to 3- | 90° additional turn |
- Replace the bolts that were tightened with an additional turn.
-- Tighten the bolts in the steps shown in the sequence:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -2 and 3- | 50 Nm |
| 2. | -1- | 130 Nm |
| 3. | -1 to 3- | 90° additional turn |