Valve Guides, Checking

Special Tools And Workshop Equipment Required

Test Sequence

Courtesy of AUDI OF AMERICA, LLC

If the valve is to be replaced as part of a repair, use a new valve for the measurement.
Due to different stem diameters, only use an intake valve in the intake valve guide and an exhaust valve in the exhaust valve guide.

-- Secure the Dial Gauge - 0-10mm:VAS6079 with the Dial Gauge Holder:VW387 on the cylinder head.

-- Place the valve in the valve guide.

-- Determine the tilting clearance.

-- If the wear limit is exceeded, measure using new valves.

-- Replace the cylinder head if the wear limit is still exceeded. The valve guides cannot be replaced.