Brake Pads, Removing And Installing: Notes
NOTE:
Clean the bolts and nuts before reusing.
Always replace self-locking nuts and bolts.
Always replace damaged nuts and bolts.
Installation Position Of The Brake Caliper On A Torsion Beam Axle A :
1 -Brake Caliper
Installation Position Of Multi-Link Suspension B :
1 -Brake Caliper
Special Tools And Workshop Equipment Required
- Vehicle Diagnostic Tester
- Torque Wrench 1331 5-50 Nm :VAG1331
- Tool Holder :VAS6564/2 from Brake Bleeding Tool Set:VAS6564
- Torque Wrench 1331 Insert - Ratchet Head:VAS6784
- Piston Resetting Tool:T10145
- Hex Bit - 7mm:T10503
- Lithium Grease:G 052 150 A2 . Refer to the Parts Information.