Overview - Bumper Cover, Vehicles From My 2017

Fig 1: Bumper Cover Components Location (Vehicles From MY 2017)

Courtesy of AUDI OF AMERICA, LLC

1. Rear Reflector
   • Removing and Installing. Refer to REFLECTOR, REMOVING AND INSTALLING .
2. Rear Bumper Cover
   • Removing and Installing. Refer to BUMPER COVER, REMOVING AND INSTALLING .
3. Cover
4. Bolt
   • 2 Nm
5. Mount
   • for lane change assistance control module
6. Lane Change Assistance Control Module
   • Equipped on some models
   • Overview. Refer to OVERVIEW - LANE CHANGE ASSISTANCE .
7. Bolt
   • Quantity: 3
   • Tightening sequence. Refer to Figure.
8. Nut
   • Tightening sequence. Refer to Figure.
9. Side Mount
   • For the bumper cover.
   • Removing and Installing. Refer to SIDE BUMPER COVER MOUNT, REMOVING AND INSTALLING .
10. Upper Guide Piece
    • For securing the bumper cover
    • Removing and Installing. Refer to UPPER GUIDE PIECE, REMOVING AND INSTALLING .
11. Locking Mechanism
    • For attaching the rear bumper cover to the upper mount
12. Bolt
    • Tightening sequence. Refer to Figure.
13. Cover
    • Quantity: 2
14. Nut
    • 5 Nm
    • Quantity: 4
15. Mount
    • For the bumper cover
    • Removing and Installing. Refer to BUMPER COVER MOUNT, REMOVING AND INSTALLING .
16. Nut
    • 2 Nm
    • Quantity: 2
17. Cover
    • For the towing eye
18. Bumper Cover Lower Section
    • There are different versions.
    • Removing and Installing. Refer to BUMPER COVER LOWER SECTION, REMOVING AND INSTALLING .
19. Trim
    • Only S line version
    • For the bumper cover lower section
    • Removing and Installing. Refer to BUMPER COVER LOWER SECTION TRIM, REMOVING AND INSTALLING, S LINE FROM MY 2017 .