Bumper Cover, Removing And Installing, Vehicles With Side Auxiliary Radiator: Removing

-- Left: Push in the front wheel and loosen the wheel housing liner in the area of the front bumper cover.

-- Right: remove the front right wheel housing liner. Refer to FRONT WHEEL HOUSING LINER, REMOVING AND INSTALLING .

-- Place a drip tray under the separating point for the washer fluid hose.

-- Remove the water drain hose -1- from the headlamp washer pump -2- to do this push the release button.

Courtesy of AUDI OF AMERICA, LLC

-- Seal the hose coupling with clean plugs from the : VAS6122  .

-- Free up the washer fluid hose -3-.

-- Disconnect the central connector -arrow-.

Courtesy of AUDI OF AMERICA, LLC

-- Push the loosened wheel housing liner aside and remove the bolts -arrows-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -1 and 2-.

Courtesy of AUDI OF AMERICA, LLC

-- Disengage the side wall -3- from the front side panel -arrow- (in illustration) and remove the bumper cover forward with a second technician.