Molded Foam Part, Removing And Installing: Removing

-- Remove the front bumper cover. Refer to BUMPER COVER, REMOVING AND INSTALLING .

-- Remove screws -arrows-, and remove the bracket -1-.

Courtesy of AUDI OF AMERICA, LLC

-- If installed, push through the cable tie on the pedestrian protection crash sensor bracket.

-- Release catches -1- -arrow- and disengage the molded foam piece -2- from the impact member.

Courtesy of AUDI OF AMERICA, LLC

-- Vehicles through MY 2016: if equipped free up the vacuum line -1- from the molded foam part -2-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the molded foam part.