Remove Individual Wire
WARNING:
- Follow all pyrotechnic components safety precautions, refer to PYROTECHNIC COMPONENTS SAFETY PRECAUTIONS .
- Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.
-- Remove the front seat, refer to FRONT SEAT, REMOVING AND INSTALLING .
-- Fasten the front seat on the Engine/Transmission Holder - Seat Repair Fixture :VAS6136 , refer to FRONT SEAT, MOUNTING ON FIXTURE FOR SEAT REPAIR .
-- Remove the rear bracket for the wire routing from the seat pan with a screwdriver.
-- Separate the wiring bracket -2 and 5- and cable tie -3 and 4-.
NOTE:
For replacing a faulty wire or the side airbag, refer to WIRING HARNESS AND CONNECTOR REPAIRS or FRONT SIDE AIRBAG WITH IGNITER, REMOVING AND INSTALLING .
-- Remove the individual wire from the protective cover -1-.