Entry Assistance Release Cable A, Removing And Installing: Removing
- Follow all pyrotechnic components safety precautions, refer to PYROTECHNIC COMPONENTS SAFETY PRECAUTIONS .
- Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.
-- Remove the front seat, refer to FRONT SEAT, REMOVING AND INSTALLING .
-- Fasten the front seat on the Engine/Transmission Holder - Seat Repair Fixture :VAS6136 , refer to FRONT SEAT, MOUNTING ON FIXTURE FOR SEAT REPAIR .
-- Move the front seat all the way up.
-- Remove the seat side trim on the tunnel side, refer to SEAT SIDE TRIM ON THE TUNNEL SIDE, REMOVING AND INSTALLING .
-- Turn the backrest adjustment hand wheel forward until stop.
-- Unclip the cable A bracket -1- from the backrest.
-- Disengage the release cable A -item 2- from the lever on the backrest hinge.
-- Disengage the cable A bracket -1- for entry assistance from the bracket on the seat pan.
-- Unclip the bracket -2- for the release cable from the seat pan.
-- Disengage the release cable A from the seat longitudinal adjuster -arrow- and remove.