Connecting Cable, Removing And Installing, Standard/Sport Seat: Removing
WARNING:
- Follow all pyrotechnic components safety precautions, refer to PYROTECHNIC COMPONENTS SAFETY PRECAUTIONS .
- Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.
-- Remove the front seat, refer to FRONT SEAT, REMOVING AND INSTALLING .
-- Fasten the front seat on the Engine/Transmission Holder - Seat Repair Fixture :VAS6136 , refer to FRONT SEAT, MOUNTING ON FIXTURE FOR SEAT REPAIR .
-- Remove the backrest release trim, refer to BACKREST RELEASE TRIM, REMOVING AND INSTALLING .
-- Remove backrest seat cover and cushion, refer to BACKREST COVER AND CUSHION, REMOVING AND INSTALLING .
-- Pivot the backrest release bearing -1- upward in direction of -arrow- until stop and hold in this position.
-- Disengage the connecting cable -3- at the mount.
-- Pivot the operating lever -2- upward until it stops.
-- Disengage and remove the connecting cable from the operating lever.