Backrest Release Cable, Adjusting
Make sure the backrest is locked (zero position), otherwise it could tip forward accidentally.
The following prerequisites must be met to adjust:
- The upholstery must be removed from the backrest.
- Backrest release -2- to the lower stop (backrest locks).
-- Pivot the backrest release bearing -1- upward until a distance of -a- = 2 to 4 mm is between the backrest frame stop surface -arrow A- and the bearing stop -arrow B-.
-- Secure the backrest release bearing in this position, using for example an angled metal rod.
-- Adjust the release cables on both release cable adjusters -1 and 2-.
-- To adjust, turn the upper part -3- and the lower part -4- contrary to each other.
-- Adjust the cable so it is free of play and tension.
The illustration only shows one side of the retainer.
When adjusting cables -1-, they must not be tensioned at the backrest release -2-.
-- After adjusting release cables, perform a functionality test of the backrest lock.
-- If it does not release or only releases partially, check the release cable routing or repeat the adjustment.