LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A3 Premium, 2D Convertible >> Repair and Diagnosis >> Accessories & Equipment >> Seats >> Seat Frames -- (A3 Cabriolet) >> 72 Seat Frames >> Front Seats >> Airbag Adapter, Connecting And Disconnecting >> Airbag Connector, Connecting

Airbag Connector, Connecting

WARNING:
  • Follow all pyrotechnic components safety precautions, refer to PYROTECHNIC COMPONENTS SAFETY PRECAUTIONS .
  • Before handling pyrotechnic components (for example, connecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.

Connecting the airbag wiring harnesses happens in reverse order, noting the following:

NOTE:

Make sure the connectors are installed correctly and are secure.

WARNING:

Ignition must be on when connecting battery. If pyrotechnic components (for example, airbag, belt tensioner) are not repaired correctly, they may deploy unintentionally after connecting battery. There must not be anyone inside the vehicle when connecting the battery.

-- Connect the battery GND cable with the ignition turned on, refer to BATTERY, DISCONNECTING AND CONNECTING (A3 / A3 CABRIOLET) .

NOTE:

If the Airbag Indicator Lamp -K75- indicates a fault, check the Diagnostic Trouble Code (DTC) memory, erase it and check it again, refer to Vehicle Diagnostic Tester.

scientia non olet · About LEMON Manuals