Trailer Hitch Socket, Removing And Installing - Version 4: Removing

NOTE:

During installation, install the cable ties at the same location.

-- Turn off the ignition and all electrical equipment.

-- Move out the trailer hitch.

-- Cut through the cable tie -3-.

-- Remove the bolts -2-.

-- Remove the socket from the trailer hitch -1-.

-- Release the retainers -arrows-.

-- At the same time remove the cap -1- from the socket.

-- Remove rubber cover -2-.

-- Release the clips -arrows- and press multiple connector -2- out of socket -1-.

-- Release the clips -arrows- and remove retainer -1- from multiple connector -3-.

NOTE:

Carefully remove the retainer so that contacts -2- of the multiple connector are not disconnected from the wiring harness.