Head Curtain Airbag With Igniter, Removing And Installing, Through My 2010: Removing

WARNING:

Follow all Safety Precautions when working with pyrotechnic components. Refer to PYROTECHNIC COMPONENTS SAFETY PRECAUTIONS .
Follow all regulations when disposing of pyrotechnic components. Refer to AIRBAG, BELT TENSIONER AND BATTERY CUT-OUT UNITS, STORING, TRANSPORTING AND DISPOSING .

-- Turn on the ignition.

-- Disconnect the battery ground cable with the ignition turned on. Refer to GROUND CABLE WITH BATTERY MONITORING CONTROL MODULE -J367-, REMOVING AND INSTALLING / BATTERY, DISCONNECTING AND CONNECTING .

-- Remove the headliner. Refer to HEADLINER, REMOVING AND INSTALLING .

-- Remove head curtain airbag bolt -3- on the A-pillar.

Fig 1: Identifying Head Curtain Airbag Bolts And Clips

Courtesy of AUDI OF AMERICA, LLC

-- Remove the head-level airbag from the clips -1- and -2-.

Fig 2: Removing Cap Nuts

Courtesy of AUDI OF AMERICA, LLC

WARNING:

Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.

-- Disconnect the connector -1-.

-- To do this, release the connector lock -3- using a small screwdriver -1- and remove the electrical connector -2- from the head curtain airbag.

Fig 3: Identifying Releasing Connector Lock

Courtesy of AUDI OF AMERICA, LLC

-- Remove cap nuts -2- and -3-.

Fig 4: Removing Cap Nuts

Courtesy of AUDI OF AMERICA, LLC

-- Disengage the head curtain airbag retaining tab clips -1- from the body by pressing the locking mechanisms together -arrows- using needle nose pliers or o-ring pliers.

Fig 5: Side Curtain Airbag Retaining Tab Clips, Removal

Courtesy of AUDI OF AMERICA, LLC

-- Remove head curtain airbag from vehicle.