RIGHT RETAINING PLATE WITH THE Right Footwell Door Motor -V109- AND Right Center Vent Motor -V111-, DISASSEMBLING AND ASSEMBLING

The retaining plate with the Right Footwell Door Motor -V10- and the Right Center Vent Motor -V111- is only installed on vehicles equipped with the "Convenience" A/C system.

Currently in this vehicle, all actuators are identical in construction. During the basic setting, the actuators are assigned and adapted corresponding to the switching sequence of the wiring. If this sequence does not conform the specification, the adjustment motors will adapt incorrectly and the door control will be wrong. Refer to MAIN WIRING DIAGRAM FOR A/C SYSTEM ACTUATORS (A/C system actuators block diagram).

The actuator shaft does not have a stop; therefore the shaft of these actuators can be inserted into the curved washer in any position.

Depending on the production date, there are different versions of the levers and connecting elements on the A/C unit. At the start of production, the levers -A- were installed with a closed pin and the connecting rod -B-. In MY 2008, the levers -C- have a slotted pin and connecting rod -D-. When replacing, be sure to use the correct version. .

Fig 1: Air Conditioner, Levers And Connecting Elements

Courtesy of AUDI OF AMERICA, LLC