Drive Plate, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2017 Audi S5, 2016 Audi S5, 2016 Audi S4, 2015 Audi S5, and 2015 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

Tightening specification: 60 Nm + 90° turn.

NOTE:

Replace the bolts that were tightened with an additional turn.

There is a needled bearing in the drive plate. Check if the needle bearing is inserted before installing. Remove needle bearing from drive plate and install. Refer to NEEDLE BEARING IN DRIVE PLATE, REPLACING .

-- Be careful of the alignment bushings during installation.

-- Turn the Counterhold - Flywheel 10-201 to tighten the bolts.