Cover And Cushion, Assembly Overview, Backrest Without A Pass-Through

NOTE:

In the illustration is 2/3 left rear seat is shown.

Fig 1: Identifying Backrest Cover And Cushion

Courtesy of AUDI OF AMERICA, LLC

1. Cushion Clip
   • For securing cover to upholstery
   • Always replace if removed
   • Install in same location as before removal
2. Wire
   • In foam in upholstery
   • For securing cover to upholstery
3. Contour Strip
   • Sewn into cover
   • For securing cover to upholstery
4. Cover
   • Cover with upholstery, removing and installing. Refer to BACKREST COVER AND PADDING WITHOUT A PASS-THROUGH, REMOVING AND INSTALLING 
   • Cover, Separating from Cushion and Connecting. Refer to BACKREST COVER AND CUSHION, SEPARATING 
5. Clamping Strip
   • Sewn into cover
   • For attaching the cover to the backrest frame
6. Cushion
   • Cover with upholstery, removing and installing. Refer to BACKREST COVER AND PADDING WITHOUT A PASS-THROUGH, REMOVING AND INSTALLING 
   • Cover, Separating from Cushion and Connecting. Refer to BACKREST COVER AND CUSHION, SEPARATING 
7. Backrest Frame