LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S8 Plus >> Repair and Diagnosis >> Steering >> Steering Column >> 48 Steering >> Power Steering Hydraulics >> Overview - Hydraulic Lines And Reservoir >> Overview - Hydraulic Lines And Reservoir, Vehicles With 8-Cylinder Engine >> Intake Hose from the Lower Reservoir to the Power Steering Pump

Intake Hose from the Lower Reservoir to the Power Steering Pump

-- The intake hose -2- is attached to the subframe -4- with two bolts -arrows-.

Fig 1: Installing Intake Hose From Lower Reservoir To Power Steering Pump
GWWA48-10670Courtesy of AUDI OF AMERICA, LLC

1 -

Lower reservoir

3 -

Power steering pump

Bolt tightening specification -arrow- : 9 Nm

Intake hose connection on the power steering pump (vehicles with dynamic steering). Refer to Pay attention to the installed position of the pressure line. The angle between the pressure line and the power steering pump axle is approximately 7°. 

Intake hose connection on the power steering pump (vehicles without dynamic steering). Refer to Removing 

NOTE:

Align the hoses and lines on the connections so that the color markings match up.

scientia non olet · About LEMON Manuals